Section 2: Installation & Setup
2-10
RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide
020-100038-02 Rev. 1 (09/08)
To adjust the 6-axis adjuster:
1.
Center the image on screen, by adjusting vertical and/or horizontal position.
2.
Zoom the image out (make smaller) until it fits within the borders of the
screen.
3.
Adjust keystone and tilt.
4.
Zoom the image in (make larger) to fill the screen.
5.
Repeat any adjustments until the image appears correctly.
TIPS
:
1)
When adjusting, make ¼ to ½ turns of the adjustment knob(s). This will
allow you to control adjustments and return to previous positions relatively quickly.
2)
Adjustment screw #4 controls the mode for screws #3 and #6. Always adjust this
screw first until it reaches its position, then the other. This adjustment screw has two
positions,
FULL IN
and
FULL OUT
,
which implies the screw reaches the extent of its
range in the clock-wise or counter-clockwise direction.
3)
Do not over-adjust screws.
When you begin to feel a slight resistance STOP adjusting, as this indicates you have
reached the end of the adjustment range. Refer to
Section 8 - Specifications
for the
adjuster’s range of movement from the factory set nominal position.
Figure 2.11. 6-Axis Adjustments
Summary of Contents for RPMSP-D120U
