Christie RPMSP-D120U, Setup Manual

Page: 11 / 51

Section 2: Installation & Setup
RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide 2-3
020-100038-02 Rev. 1 (09/08)
The following subsection outlines the steps necessary to complete the installation of a
RPMX/RPMSP-D120U and the RPMSP-D275U projector as a stand alone or
multiple projector installation.
For instructions on how to install your projector into the TotalVIEW
™
50” or 67”
cube enclosure, refer to the separate Cube Installation Manual provided in the User’s
Kit.
Unpack the projector
The projector is carefully packaged and shipped fully assembled in the lens-vertical
(90 degree) configuration. When you receive your projector it is important you do the
following to prepare it for installation:
•
Remove the projector from the box and discard any packing material
surrounding the modules.
Note: An L-shaped bracket, used to change the
projector’s configuration, is shipped loosely in the box with the projector. Set
this aside for future use.
•
Ensure all cable connections are secure. Reconnect any cables that may have
come loose during shipping. See Figure 2.1.
Figure 2.1. Internal Cable Connections
•
Check lamp handles . These handles must lay flat against the lamp
surface otherwise they will interfere with lamp operation.
•
Remove the lock screw located on the mechanical lamp changer .
(Figure 2.2.) This screw is used for shipping purposes only and must be
removed prior to turning the projector on.
Failure to do so can result in
projector damage .
2.3 Installation &
Setup
Step 1 h