56
Configuring communications
Using the web interface
To control the projector through the web interface, do the following:
1. Start up the web browser on your computer or mobile devices.
2. Enter the IP address set on the projector into the URL of the web browser.
3. Enter the user name and password to login. After a successful login, you can control the
projector over the web interface.
Using the RS-232C interface
To control the projector through the RS-232C interface, do the following:
1. Connect your computer and the projector directly using the RS-232 cable.
2. Set the same baud rate in both your computer and projector. Use commands to control the
projector.
Re-connecting the network
After the network is disconnected and timeout via RJ-45/HDBaseT/Wifi, the browser will refresh the
page automatically and show "HTTP404 (Not Found)" error message.
If user wants to re-control the projector, user must login in the control page with account and
password again.
Adjusting WLAN setting
Set up network configuration for wireless networking.
1. Select
Menu
>
Configuration
>
Communications
>
WLAN
.
2. Set up the appropriate setting:
•
SSID
—Displays the SSID of the wireless network.
•
Enable
—Enables or disables the wireless functionality.
•
Start IP
—Assigns the start IP address of the wireless network.
•
End IP
—Assigns the end IP address of the wireless network.
•
Subnet Mask
—Assigns the subnet mask of the wireless.
•
Default Gateway
—Assigns the gateway of the wireless.
3. To apply the WLAN settings, select
Apply
.
Adjusting network setting
Set up network configuration setting, such as reset back to default.
1. Select
Menu
>
Configuration
>
Communications
>
Network
.
2. Set up the appropriate network setting:
•
Show Network Message
—Enables or disables to display of the network message.
GS Series 2K User Manual - DWU880-GS, DWU880A-GS, DWU9200-GS, DWU1100-GS, DWU1100A-GS
020-001908-01 Rev. 1 (
02
-202
2
)
Copyright © 202
2
Christie Digital Systems USA Inc. All rights reserved.