Christie DHD410S, Service Manual

Page: 13 / 77

Service setups
DHD410S Service Manual 13
020-001481-01 Rev. 1 (10-2018)
Test inspection
Complete the required update according to the table below for part replacements indicated by X.
PC mode
To check if noise or flicker exists on the projected screen, connect a PC to the projector.
When performing a functional test, to optimize the image before testing, adjust the zoom and focus.
• DHD410S: Analog 1920 x 1080 @60Hz
Adjusting the frequency and tracking boundary
If the projected image appears with noise or flicker, adjust the frequency and tracking boundary.
Update Parts replaced
Main board Combiner IR Camera Filter Wheel Light engine Firmware
Firmware update x x
Wheel index x x x x
Re-write LD hour
usage
x
Factory reset x
LD calibration x x
ADC calibration x x
IR Camera Test x
Network Test x
EDID x
If the color appears abnormal after changing Main Board Module, enter into Factory Mode
Menu and perform a Wheel index adjustment.
Warning! If not avoided, the following could result in death or serious injury.
• Do not stare into beam when the projector is on. The bright light may result in permanent eye
damage.
ID Part name Description
1 Test equipment Video generator
2 Test pattern General-1 or Master