![background image](http://html1.mh-extra.com/html/christie/cp2208/cp2208_user-manual_2603719021.webp)
Item
Description
• RUN—The LED flashes green when the projector is operating normally. If the LED is not
illuminated or solid green, a communication, software, or hardware error has occurred. If the LED
is yellow, the projector cannot communicate with the touch panel controller (TPC).
• PIB—The LED is green when the projector intelligence board (PIB) is detected and operating
correctly. A red LED indicates a communication error. A flashing red LED indicates the PIB is not
installed correctly. If the LED is not illuminated, the PIB is inactive.
• ICP—The LED is green when the ICP is operating correctly. A red LED indicates a communication
issue. If the LED is not illuminated, the ICP is inactive.
• IMB—The LED is green when the integrated media block (IMB) is operating correctly. A red LED
indicates a communication issue. If the LED is not illuminated, the IMB is inactive.
E
Indicates marriage status. In full power mode, a green LED indicates that the projector is properly
married and encrypted content can be displayed. A red LED indicates marriage is broken and
encrypted content cannot be displayed.
F
Turns the projector and the on and opens the douser. Press and hold the button to close the douser,
turn the off, and keep the power on. We recommend that you use this button only when the TPC is
unavailable.
G
Resets the projector electronics. After restarting, the projector returns to its previous power mode.
You must turn on the light source manually.
H
Connects the projector to 3D devices.
I
Connects the projector to Christie or third-party automation equipment.
J
Connects the projector to a 10Base-T/100Base-TX Ethernet connection.
K
Connects the projector to high-definition cinema sources. The connectors can be used together to
deliver Dual Link HD-DVI following the SMPTE 372M standard.
L
Connects the projector to the building fire alarm so the light source can be shut down in the event of
a fire. If you are not using the connection, leave the factory installed jumper cable in place.
Wire the fire alarm circuit on the projector to a normally closed, dry contact building fire alarm circuit.
When the contacts open, the light source shuts down and cannot be turned back on until the circuit is
closed and a light on command is sent to the projector.
We recommend using twisted pair wiring, minimum 24 AWG. The circuit should be left floating, do not
connect to ground.
Connecting the projector to a computer
To display content from a computer, connect it to the projector.
1.
2. To communicate with the projector, add the projector to the same network as the computer.
Installing and setting up
CP2208 User Guide
21
020-101916-03 Rev. 1 (12-20120)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
Summary of Contents for CP2208
Page 1: ...User Guide 020 101916 03 CP2208 ...
Page 94: ......