4. Plug the Remote Power Rack Shelf into the building outlets in the wall or the floor.
Logging in to the Remote Power Rack Shelf web interface
To make changes to the Remote Power Rack Shelf, use Internet Explorer.
1. Connect a computer to the Remote Power Rack Shelf with a network crossover cable.
2. To access the web interface, in the Control Panel, change the IP address and subnet mask of
the computer to be on the same subnet as the Remote Power Rack Shelf.
If the IP address and subnet mask on the Remote Power Rack Shelf have not been changed
from the default, use the following values on the computer:
•
IP address: 10.10.10.202
•
Subnet mask: 255.255.255.0
3. Turn off any browser pop-up blockers.
4. In the browser address bar, type the IP address of the Remote Power Rack Shelf device.
The default IP address is 10.10.10.201.
If you have changed the IP address of the Remote Power Rack Shelf, the IP address and
subnet mask of the computer must also be changed.
The IP address for the web interface is one digit higher than the IP address of the device. For
example, when the IP address of the device is 10.10.10.201, the address of the web interface
is 10.10.10.202.
5. If prompted, run the MSXML add-on.
6. Log in to the Remote Power Rack Shelf with your username and password.
The default username is Admin, and the default password is 1234.
Changing the IP address of the Remote Power Rack Shelf
In an environment where there are multiple Remote Power Rack Shelf devices, you must have a
unique IP address for each device.
1. Select Communications > Configure Communication Parameters.
2. Set the new IP address for the Remote Power Rack Shelf.
3. Click Submit Changes.
After the IP address has been changed from the web interface, close the browser window and
then open it using the new IP address.
Installing a display panel
FHD553-XE-R and FHD553-XE-HR LCD Panels User Guide
21
020-001198-04 Rev. 1 (01-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.
