Kinetec Kinevia™ / Kinetec Kinevia Duo™
EN
19/44
Cardio kit settings
a) To use the Kinevia cardio kit, connect the heart rate
receiver to the jack socket (13) at the top of the touch
screen (the POLAR logo on the receiver should be
towards you).
b) Place the emitter centred on the chest (slightly dampen
the emitter for better conductivity).
c)
Attach the thoracic belt clip closure.
Receiver
Emitter
The belt length is adjustable. Make sure the thoracic
belt is not too tight.
Make sure the thoracic belt cannot slip.
d) Once the thoracic belt is properly attached and the receiver
connected, the Kinevia displays your heart rate on the
screen during training (see section 8.3.3 on page 24).
WARNING
DAMAGE TO THE KINEVIA DUE TO INCORRECT HANDLING
The Kinevia cardio kit belt must never be folded.
The cardio kit must not be exposed to direct sunlight for long periods.
Standby mode
◦
Activating standby mode:
Standby mode is activated by pressing anywhere on the screen for about 5 seconds.
◦
Exiting standby mode:
Standby mode is disabled by pressing anywhere on the screen for about 5 seconds unit the home page is
displayed.
Instructions for the proper use of the Kinevia
Installing the patient
The success of your therapy mainly depends on a correct seated position.
Follow the following instructions:
◦ If you are training from a wheelchair:
- Make sure you use a suitable wheelchair.
- The wheelchair must not tip backwards.
- Make sure the wheelchair is properly attached.
- If spasms were to appear, we especially recommend the use of the tipping prevention hooks (see section 5.4.3
on page 12).
◦ If you are training from a chair:
- Make sure the chair is stable and has a wide, flat back.
- The chair must not tip backwards.
- Do not use chairs fitted with castors (office chairs, for example).
◦ Sit straight and in a centred position. The chair or wheelchair must be centred facing the device.
