24/44
EN
Kinetec Kinevia™ / Kinetec Kinevia Duo™
⑤
Manual change of rotation direction key:
This key is used to reverse the pedal rotation direction.
Rotation direction
forwards
Rotation direction
reverse
When this key is pressed, the rotation speed drops gradually until it comes to a complete stop. The direction
changes. Then the rotation speed increases gradually until it reaches the preset value.
⑥
Active / passive / soft mode selection key:
This key is used to select the following training modes:
o
Active
:
training using your own muscular force
o
Passive
:
training using the motor
o
Soft or assisted active
:
training using your own muscular force assisted by the motor in a targeted
manner
⑦
Arm trainer / Leg trainer mode selection key:
This key is used to select the leg trainer or arm trainer operating modes. The key is enabled if, and only if,
the arm trainer is properly installed and leg training has been completed.
It is not possible to use the arm and leg trainer at the same time.
⑧
Enter exit aid key:
This key is used to move the pedals to a comfortable position allowing the patient to place or remove their
feet from the foot supports (also see section 8.4 on page 26).
⑨
Start/stop key:
This key is used to start or stop the training (also see sections 8.2.7 on page 22 and 8.2.8 on page 22).
Training command panel displays and keys
⑩
Distance covered:
This field indicates the distance covered during the training session in km.
⑪
Calories:
This field indicates the energy burned by your muscular work displayed in kcal.
⑫
Active power:
This field indicates your active pedalling power displayed in Watts.
⑩
⑪
⑫
⑬
⑭
⑮
⑯
⑱
⑰
⑲
⑳
