16/44
EN
Kinetec Kinevia™ / Kinetec Kinevia Duo™
Foot support spacing setting
The foot support spacing can be set to 4 different positions using the indexing button (14).
a) Please power off the device before setting the pedal
spacing.
b) Unscrew the indexing button (14) by about a ½ turn and
pull the anchoring pin out of the hole.
c)
Move the foot support to the required position until the
anchoring pin returns to the hole.
d) Screw back the indexing button (14).
e) Repeat steps b and c for the second foot support.
Make sure the two foot supports are set to the same
distance.
WARNING
RISK OF INJURY CAUSED BY UNTIGHTENED SUPPORTS
Make sure the white anchoring bolt is always properly tightened.
Pedal radius setting
The radius can be continuously set between 50 and 125 mm.
a) Please power off the device before setting the pedal
radius.
b) Slightly unscrew the wing nuts located at the outside end
of the pedal arms (photo).
c)
Guide the foot support to the required position using both
hands.
d) Tighten the wing nuts (only tighten by hand).
e) Repeat steps b and c for the second foot support.
Make sure the pedal radius is set to an identical
position on both sides, otherwise the device will not
run in a circle.
Your knee joints should always be slightly flexed to protect your joints.
Correct the distance to the device or the pedal radius if necessary.
WARNING
RISK OF INJURY CAUSED BY UNTIGHTENED PEDAL ARMS
When making the settings, make sure the pedal arm is properly fixed.
Check that the wing nut is properly tightened before each training session.
If you experience difficulty unscrewing the wing nuts, use the loosening tool supplied below.
⑭
