SVX8016 IP PBX System User Guide
陈泽科技有限公司
- 7 -
www.stephen-tele.com
WARNING!
Make sure the output power voltage of the power outlet falls into the power range accepted by the SVX8016. You can see
the required power range value on the label beside the receptacle on the back of the SVX8016.
2.6.3.
System Startup
The status lights on the front panel will flash for a few moments during boot-up, and then remain lit, indicating the device is
on.
2.6.4.
Connect the network
Connect one end of a RJ-45 Ethernet cable to a LAN port located at the front of the SVX8016. Connect the other end to a
hub or switch. The corresponding LAN indicator on SVX8016 will flash indicating the connection is OK.
2.6.5.
Connect the computer
Connect one end of a RJ-45 Ethernet cable to another LAN port located at the front of the SVX8016. Connect the other end
to a computer. The corresponding LAN indicator on SVX8016 will flash indicating the connection is OK.
2.6.6.
Connect the telephone
Connect one end of the provided RJ-11 telephone cable to the phone jack and the other end to your phone. You can hear
some signal tones from the earpiece when you pick up the telephone handset.
NOTE:
The signal tone can not be heard from the handset before the booting process is completed. The status lights on the
front panel will flash for a few moments during boot-up and then remain lit, indicating the device is on.
2.6.7.
Connect the PSTN line
Connect one end of the RJ-11 telephone cable to wall phone jack of an incoming phone line and the other end to the line
jack at the back of the SVX8016.
WARNING!
Never connect the line to the phone jack. Otherwise, the device may be damaged.
3.
Configuration
3.1.
Initial Configuration
3.1.1.
Get the device IP address
The factory default IP address of SVX8016 is 192.168.88.86. There are two ways to get the IP address if you forgot it.