CHIEF SL-100, Instruction Manual

Page: 10 / 32

Instruction Manual SMART-LIFT Electric Ceiling Lifts
9
INSTALL THE PROJECTOR ON THE LIFT
NOTE: If desired, the projector can also set directly on the
bottom plate of the lift and not be secured by the bracket.
Maximum projector weight for this application is 35 pounds.
1. If the lift is installed in an inverted position (suspended
from the ceiling), attach the SLB adapter bracket (see
Fig. 8) to the projector by aligning the threaded holes on
the projector with the slots on the bracket and secure it
using the screws provided (refer your individual bracket
instructions).
2. If you need more space for access to the mounting tabs,
remove the ceiling pan as follows:
a. Remove the four plugs (one at each corner of the
pan), to reveal four small screws.
b. With a #1 Phillips screwdriver, remove the four
screws. The ceiling pan will release.
3. Using the six 10-24 x 1/2-in. studs on the top side of the
SLB adapter bracket, align the studs with the holes on
the underside of the lift cradle.
4. While holding the projector in place, secure the projector
using six nuts.
CAUTION: If cradles adjusted, cradle must be level (matching set
of holes must be used on the right and left side of the cradle).
5. Select the appropriate mounting holes for the cradle
within the housing:
• On the sides of the lift housing, there are five 3/16-
in.-dia. holes in a vertical line that allow for alternate
vertical positions of the cradle within the housing.
• There are also three sets of holes 1-3/4 in. apart on
each side to accommodate three positions forward-
and-back.
6. If necessary, change the position of the cradle.
Plugs
Nut
Figure 8. Projector Installation
SLB Adapter
Bracket