CHIEF SL-100, Instruction Manual

Page: 11 / 32

10
Instruction Manual SMART-LIFT Electric Ceiling Lifts
ADJUSTMENTS
To Adjust the Aim of the Projector
The aim of the projector can be adjusted in all directions, as
shown:
1. Yaw. See Fig. 9. Move the lift to its “down” position.
There are four 10-32 x 1/2-in. pan-head screws (two on
each side) inside the bottom of the cradle, that secure the
left and right horizontal positions. Loosen these screws
slightly , move the cradle to the desired position, and
retighten the screws.
CAUTION : The pan-head screws MUST be relocated in the
matching holes on both sides if you shift positions.
2. Pitch. See Fig. 10. There are four 10-32 x 1/2-in. pan-
head screws (two on each side) on the outside of the car-
riage. Loosen these screws
slightly , tip the carriage in
the slotted holes to the desired angle, and retighten the
screws.
3. Roll. See Fig. 11. There are four 10-32 x 1/2-in. pan-
head screws in U-slots at the upper outside corners of
the cradle assembly. Slightly loosen these screws, gently
rock the cradle to the desired position, and retighten the
screws.
5. Plug the projector’s power cord into the outlet into one of
the two outlets inside the lift. One outlet is switched and
the other is continuously live.
Adjust the position of the projector for optimum projected
image alignment.
Loosen Screw 4 Places
P P
N
Figure 9. Yaw Adjustment
Figure 10. Pitch Adjustment
Figure 11. Roll Adjustment
Roll adjustment
screws
Pitch adjustment screws