CHIEF SL-100, Instruction Manual

Page: 18 / 32

17
Instruction Manual SMART-LIFT Electric Ceiling Lifts
Remote (RC-10)
Wire for remote (RC-10) (Figure 21) operation as follows:
1. Install a jumper wire between terminals #2 and
terminal #5 (see Figure 22).
2. Connect the white wire of the RC-10 controller unit to
terminal #1 (see Figure 23).
3. Connect the red wire of the RC-10 controller unit to
terminal #2.
4. Connect the black wire of the RC-10 controller unit to
terminal #5.
5. Connect the power source to the lift.
NOTE: If the unit does not activate, check to make sure the 9 volt
battery is working and make sure the dip switches in the send-
ing unit match the dip switch settings in the controller unit (see
Figure 24).
Figure 22. Jumper Connection
White Wire
Black Wire
Red Wire
Use Category II Wiring
Figure 21. Remote Wiring Connections
White lead
Black lead
Red lead
Figure 23. Contacts Connection
Figure 24. Dip Switches