Instruction Manual
SMART-LIFT Electric Ceiling Lifts
13
(Optional) Installing Wiring Cover
An optional wiring cover may be installed to further protect
wiring from mechanical damage.
WARNING: Make sure that power to SL-150 is OFF before
proceeding!
1.
Remove the control harness, and place cover (included
in kit) over hole. (See Figure 13)
2.
Make control connections directly to the control box. (See
Inside Terminal Wiring Examples section)
3.
Install the right back wiring cover against the control box.
4.
Fit left back wiring cover against right back cover and
place against control box. Install self-drilling screws.
(See Figure 13)
5.
Install small wiring cover to the right of the right back wir-
ing cover and fasten with self-drilling screws.
(See Figure 13)
6. Fit the triple switch cover over the left back wiring cover.
Be sure that triple switch cover does not interfere with
operation of switches.
Figure 13. Install Optional Wiring Cover
1
5
6
3
4
(NOTE: Some components not shown for clarity.)
Control harness
behind here
(cover shown installed)
NOTE: Left and right back covers
must not touch drive shaft.
Summary of Contents for SL-100
