Chicco Stroll'in'2, Manual

Page: 15 / 84

14 15
outwards (Fig. 6C).
7. Insert the bumper bar/children’s tray in the dedicated slots
until they click into place (Fig. 7A). To remove the bumper bar/
children’s tray press the two side buttons and pull towards
you (Fig. 7B).
WARNING: Never use the bumper bar/children’s tray to lift the
stroller with your child sitting in it.
SAFETY HARNESS
On the front seat the stroller has a five-point safety harness which
consists of two shoulder straps, a waist strap and a crotch strap
with buckle. The rear seat has a three-point safety harness which
consists of a waist strap and a crotch strap with buckle.
8. Make sure the shoulder straps are at a suitable height for
your child: adjust if necessary (Fig. 8).
9. After placing your child in the front seat, insert the two forks
in the buckle (Fig. 9A) and adjust the waist belt if necessary
by pressing the buttons at the side of the buckle. To unfasten
the waist belt press the central button (Fig. 9B).
10. After placing the second child in the rear seat, adjust the
waist belt by pressing the buttons at the side of the buck-
le (Fig. 10A). To unfasten the waist belt press the central
button (Fig. 10B).
WARNING: The use of the crotch strap, waist strap and safety
harness is necessary to guarantee the safety of your child.
WARNING: After removing the safety harness (e.g. to wash it),
ensure that the harness is reassembled correctly using the
anchorage points. The harness must be re adjusted.
HOW TO ADJUST THE BACKREST
11. The backrest can be adjusted into two positions using the
lever at the rear. To lower the backrest pull the lever up and
push the backrest back (Fig. 11). Vice versa, to straighten the
backrest lift the lever or push it forwards.
WARNING: These operations may be more difficult if your child
is sitting in the chair.
REAR BRAKES
The rear wheels have linked brakes, which can be applied
simultaneously on both rear wheels using one pedal only.
12. To apply the brakes, press one of the two pedals at the sides
of the rear wheels down, as shown in Figure 12.
13. To release the brakes, push up one of the two pedals to the
sides of the rear wheels, as shown in Figure 13.
SUN CANOPY
WARNING: The canopy must be fixed to both sides of the
stroller. Ensure that the canopy is correctly secured (see point 6).
14. To open the canopy, push the front arch forward (Fig. 14).
15. For greater protection from the sun’s rays it is possible to
increase the fabric surface of the canopy by extending the
wings and the central fabric segment folded under the
canopy (Fig. 15A-15B).
CLOSING THE STROLLER
WARNING: When opening the stroller, make sure that your child
or other children are at a safe distance. Make sure that during
these operations the moving parts of the stroller do not come
into contact with your child. Before closing the stroller, make
sure that the storage basket is empty and the canopy is closed.
The stroller has a closing device that can be used with one hand.
16. To close the stroller push cursor “A” on the closing device (Fig.
16A) outwards and lift the tube at the same time (Fig. 16B).
17. When closed, the stroller stands up on its own (Fig. 17).
FITTING AND REMOVING THE STROLLER LINING
18. To remove the lining from the front seat lower the backrest
completely by pulling the lever and pushing it forwards
(Fig. 18A), remove the three plastic side wings (left and
right) from the backrest structure (Fig. 18B) and remove the
lining from the top edge of the backrest (Fig. 18C). Undo
the buttons under the seat and remove the fabric from the
seat (Fig. 18D). Then remove the safety harness by passing
the straps through the holes on the backrest and the seat
(Fig. 18E-18F-18G).
19. To remove the fabric from the rear seat, pass the crotch
strap and waist strap through the holes as shown in Figures
19A and 19B.
To replace the cover on the stroller, repeat these steps in reverse
order and reassemble the safety harness by passing the straps
through the fabric holes.
INSTALLING THE CHICCO KEYFIT CAR SEAT
The CHICCO KEYFIT car seat can be attached to the stroller.
WARNING: The CHICCO KEYFIT car seat can only be attached
to the stroller in the forward facing position.
20. To install the CHICCO KEYFIT car seat to the stroller remove
the bumper bar/tray and completely lower the backrest
(Fig. 20A). Position the car seat as shown in Figure 20B until
you hear a double click.
WARNING: Make sure it is attached properly by pulling the car
seat upwards.
21. To remove the car seat from the stroller structure push the
lever on the car seat and lift it up (Fig. 21).
REAR FOOTBOARD
At the back of the stroller there is a footboard for transporting
a second child in the standing position. This can only be used
when the rear seat has been completely raised.
22. To raise the seat push it upwards (Fig. 22).
WARNING: When pushing the stroller do not allow your child
to stand on the footboard facing backwards. Do not allow your
child to stand on the seat. To prevent falls, your child must hold
the handles and keep both feet on the footboard (Fig. 22A-22B).
RAIN COVER
23. To fit the rain cover, fasten the straps around the stroller’s
frame, in the positions shown in Fig. 23 (the steps are to be
repeated on both sides of the stroller). When you have fin-
ished using the rain cover, allow it to dry properly if it is wet.
WARNING: The rain cover cannot be used on the stroller without
a hood, as it may cause suffocation.
WARNING: When the rain cover is fitted on the stroller, never
leave it exposed to direct sunlight with your child inside, as the
temperature will rise considerably.
WARRANTY
The product is guaranteed against any conformity defect in
normal conditions of use as provided for by the instructions
for use. The warranty shall not therefore apply in the case of
damages caused by improper use, wear or accidental events.
For the duration of warranty on conformity defects please
refer to the specific provisions of national laws applicable in
the country of purchase, where provided.