V1.1, May 12, 2020
Companion User Manual
©Copyright 2020 by CHEELCARE
TM
. All rights reserved.
P a g e
|
13
Assembling the Docking Module for Rigid Manual Wheelchair
1. Unscrew the top halves of the clamps from the pre-assembled part #1. Locate the
package with the set of rubber rings and strip. Position part #1 under the camber tube of
the wheelchair. Depending on the diameter of the crossbar insert matching rubber ring or
strip between the clamp and tube to ensure a tight connection. Place the top halves of
the clamp over the camber tube. Secure the clamps in place, but do not tighten them yet.
You will need to adjust the position of this assembled part later.
2. Use a ruler or measuring tape to measure the length (
D
) from the front edge of the
cushion seat to the crossbar. Subtract 9 cm (3.5”) from this length. Use this measurement
(
L
) in the next step.
Clamp screws
Clamp top
halves
Clamps with
rubber rings
Clamp with
rubber strip
Clamp without
strip or ring
Distance between the crossbar
and the front edge of the cushion
D
L
