V1.1, May 12, 2020
Companion User Manual
©Copyright 2020 by CHEELCARE
TM
. All rights reserved.
P a g e
|
14
3. Position part #2 on top of part #3 at the distance
L
from the edge. Take the screws and
locknuts from the bag attached to part #2. Insert the screws from below into the holes
closest to marked location. Tighten the screws with an Allen key as you hold the locknuts
in place with the open-end wrench.
4. Unscrew clamp top halves. Position the assembled module under the crossbar of the
wheelchair. Place the top half of the clamp over the crossbar. Depending on the diameter
of the crossbar insert matching rubber ring or strip between the clamp and tube to ensure
a tight connection. Secure the clamp in place with an Allen key, but do not tighten them
yet. You will need to adjust the position of this part later.
Part #3
4 x locknuts (from bag attached to part #2)
4 x screws (from bag attached to part #2)
Part #2
L
Clamps with
rubber rings
Clamp top halves
Crossbar
L
19mm (0.75”)
25mm (1”)
28mm
(1.1”)
32mm (1.25”)
