Chauvin Arnoux C.A 6116, User Manual

Page: 2 / 96

2
WARNING, risk of DANGER! The operator must refer to these instructions whenever this danger symbol appears.
Polarity of the supply connector with direct voltage.
Current clamp.
USB socket.
Auxiliary rod.
The voltage on the terminals must not exceed 550 V.
The CE marking indicates conformity with European LVD and EMC directives.
The rubbish bin with a line through it means that in the European Union, the product must undergo selective disposal
in compliance with Directive WEEE 2002/96/EC.
Definition of measurement categories:
„
Measurement category IV corresponds to measurements taken at the source of low-voltage installations.
Example: power feeders, counters and protection devices.
„ Measurement category III corresponds to measurements on building installations.
Example: distribution panel, circuit-breakers, machines or fixed industrial devices.
„
Measurement category II corresponds to measurements taken on circuits directly connected to low-voltage installations.
Example: power supply to electro-domestic devices and portable tools.
PRECAUtIons foR UsE
This device is protected against accidental voltages of not more than 600V with respect to earth in measurement category III or
300V with respect to earth in measurement category IV (under shelter). The protection provided by the device may be compro-
mised if it is used other than as specified by the manufacturer.
„ Do not exceed the maximum rated voltage and current and the measurement category.
„ Never exceed the protection limits indicated in the specifications.
„
Comply with the conditions of use, namely the temperature, the humidity, the altitude, the degree of pollution, and the place
of use.
„
Do not use the device or its accessories if they seem damaged.
„ Do not use the device if the battery compartment cover is missing or incorrectly installed.
„
To recharge the battery, use only the mains adapter unit provided with the device.
„
To replace the battery, disconnect everything connected to the device and set the switch to OFF.
„
Do not use a battery with a damaged jacket.
„ Use connection accessories of which the overvoltage category and service voltage are greater than or equal to those of the
measuring device (600 V Cat. III or 300 V Cat. IV).
„
Troubleshooting and metrological checks must be done only by accredited skilled personnel.
„
Wear the appropriate protective gear.
Thank you for purchasing a C.A 6116 installation tester . To obtain the best service from your unit:
„
read these operating instructions carefully,
„
comply with the precautions for use.