Chattanooga Vectra Neo, User Manual

Page: 27 / 86

25
Vectra® Neo Clinical Therapy System
SETUP INSTRUCTIONS
2. Press the Remote ON/OFF toggle icon to assign or
unassign the remote to the selected treatment. The
remote can be assigned to only one treatment at
a time, however the remote can be reassigned as
needed.
When not in use, the Patient Remote/Laser Interrupt
Switch can be stored by hooking it onto the lead wire
holder clips in the same manner as lead wires and
cables (shown below).
Complete the following steps to assign the remote to a
treatment:
1. When the remote is plugged into the unit, a Remote
ON/OFF toggle icon is displayed on the Treatment
review screen in the upper right corner (shown
below).
PATIENT REMOTE/LASER INTERRUPT SWITCH
INSTALLATION
To operate the Patient Remote/Laser Interrupt Switch,
plug the remote into the device on the Rear Access Panel
receptacle, as shown below:
• Patient Remote/Laser Interrupt Switch is to be used under
supervision of a physician or licensed practitioner only.
CAUTION