33
Intelect Transport® Combo Therapy System
6.4 CHANNEL 1 STIM BOARD
A. Part Number ............................................
27419
B. Tools and Equipment Required
#1 Phillips Screwdriver
C. Channel 1 Stim Board
1. Separate Top from Bottom.
Refer to 6.1,
part
C.
2. Using the # 1 Phillips Screwdriver, remove the
four screws securing Channel 1 Stim Board to
the Stand Offs.
See Figure 6.10.
3. Carefully lift the Channel 1 Stim Board from
the unit. Make certain not to bend any of the
Header Connector Pins on the board below
during
removal.
See Figure 6.11.
4. Replace Channel 1 Stim Board in reverse
order of preceding steps. Make certain all
Header Connector Pins are properly engaged.
See Figure 6.11.
NOTE:
Do not over tighten the screws. Over
tightening will damage the threads of the
brass inserts and Stand Offs.
•
6 REMOVAL & REPLACEMENT
REMOVE
SCREWS
HEADER CONNECTOR PINS
FIGURE 6.10
FIGURE 6.11
Unplug the unit from the power source before
attempting removal or replacement procedures to
prevent electrical shock.
Care must be taken during removal and replacement
with the Header Pins. Bending the Header Pins may
cause the unit to fail.
