5. Menus
5.2 Window menu
66
Set the measurement mode, including two modes: periodical and continuous, and the default is
periodical mode.
[Measurement Time Mode]
Set the type of measurement time, including automatic and manual modes. Auto mode is selected by
default (in the auto mode the measurement time is automatically calculated by the receiver).
[Measurement Time]
Set the measurement time, the range is
500μs-900s. The default value is set to 500μs and valid when
the measurement time mode is manual.
[Frequency Step Mode]
Set the frequency step mode including the automatic and manual modes, and the automatic mode is
selected by default.
[Frequency Step Interval]
Set the frequency step interval which is valid when the frequency step mode is manual, the range is
1Hz~1GHz, the default value is 1MHz.
[Differential Mode]
Set the differential display of the spectrum. Differential mode will display when it is on, and it is in normal
display when it is off.
2) Display
The display property page under the panorama scan mode RF panorama window is shown in Fig.
5.44.
Fig. 5.44 Display property pages under the RF Panorama window
The parameters for the display-related property pages are described below:
[Highest Level]
Set the maximum display level of the window. The range is -30dBuV~110dBuV, and the default value is
set to 76.99dBuV.
[Lowest Level]
Set the minimum display level of the window. The range is -230dBuV~100dBuV, and the default value is
set to -23.01dBuV.
