Programming via programming cable
Page 50 of 80
OMEGA FLEX wall terminals WT-I/WT-II
Plug the programming cable (1) into the interface (2) on the
board of the wall terminal.
Fig. 30 – plug the programming cable
Start OMEGA software and log in.
Perform the desired operation (create locking plan, manage
devices and media, etc.).
Connect the USB plug of the programming cable with your free
USB port.
The status line of OMEGA software displays the message "Waiting
for locking device". If this message does not appear within a
couple of seconds, no driver for the programming cable has been
installed and you must install the driver manually.
For further information, please refer to the User
Manual of the CEStronics Suite which is available
free of charge at
www.ces.eu.
3
Wall terminals WT-I, WT-II, housing CES Standard
4
Wall terminals WT-I, WT-II in various housing types and
for flush installation
