Programming with the RF-Stick
OMEGA FLEX wall terminals WT-I/WT-II Page 55 of 80
After a few seconds the two status messages "System ready" and
"RF-Stick ready" appear in the status line.
Edit your locking system as desired.
You will then see a new status message "Programming required".
Go to the "Other" menu and select "Program changes".
OR
select "Programming" in the upper menu bar and click on
"Reprogramming all devices".
You will now see two new status messages in the status line
"Programming running" and "RF-Stick ready for programming".
Go with your notebook / netbook near your locking devices
(max. 10m).
Hold the RF-STICK-MASTER within reading range of your
locking device.
If the distance between the RF-Stick and the
locking device is too long (longer than 10 m), the
locking device will signal the lacking connection
with a long beep and red LEDs.
When the locking device has detected the RF-STICK-MASTER, it
signals this with a long beep and the green LEDs will go on for
about five seconds.
When the transmission starts, the green LEDs start flashing and
continue to flash until the data transmission is finished.
After the data transmission has been finished, the programming
job is deleted from the "Programming status" list.
