Fitting the wall terminal
OMEGA FLEX wall terminals WT-I/WT-II Page 41 of 80
6.2.6
Fitting the WT-II wall terminal
The WT-II control module and the reader module are supplied
preassembled. Before mounting, the control module and the
reader module must first be disassembled.
Follow the steps for disassembling the WT-II wall terminal on
pages 35.
For fitting the WT-II control module without the fitting frame, you
need already installed and prepared in-wall switch boxes. All
required cable connections must already be available in the switch
boxes. The supplied fitting frame is not required in this case.
If you are using fitting frames, please follow the fastening
instructions on page 37 ff.
Ensure that the in-wall switch boxes have been installed
horizontally.
The mounting holes of the wall terminal must always be
aligned horizontally, also when the wall terminal is
installed on in-wall switch boxes.
Ensure that all required cables have been guided through the
switch boxes without being damaged or squeezed.
Establish all required wire connections as described in the
"Connections" chapter on page 31.
