V3.0
HT Physical Mode
TX/RX Stream:
Administrator can select 1 or 2 TX/RX. The default is 2TX/2RX. If
administratior adopt model is OW-200 A1 and select use 1Tx/1Rx funciton then please note
external N-type connector only one have signal output, as shown below.
Channel Bandwidth:
The "
20/40 and 802.11ac 80
” MHz option is usually best. The other
option is available for special circumstances.
Shout GI:
Short Guard Interval, by default, it's “Enable”. it's can increase throughput. However,
it can also increase error rate in some installations, due to increased sensitivity to
radio-frequency reflections. Select the option that works best for your installation.
Aggregation:
By default, it's “
Enable
”. To “Disable” to deactivated Aggregation.
A part of the 802.11n standard (or draft-standard). It allows sending multiple frames per single
access to the medium by combining frames together into one larger frame. It creates the
larger frame by combining smaller frames with the same physical source and destination end
poi
nts and traffic class (i.e. QoS) into one large frame with a common MAC header.
Aggregation Frames:
Set frames size of Aggregation, the size
recommend use default value
is 32.
Aggregation Size:
Set aggregation size, the size
recommends use default value is 500000.
Click
“Save”
button to save your set function. Then click “Reboot” button to activate your changes.
