V3.0
1.
Device and
Software Configuration
1.1
Device appearance and RJ-45 reset function kit description
Device appearance
RJ-45 reset function kit
1.
When radio set 1Tx/1Rx then main signal
output power is the left N-type (ANT1)
connect. As refer 3.5.1 Radio 0 Basic
Setup.
2.
The device don't add the hardware return
factory value button, if software want to
reset to default then must use RJ-45 reset
function kit (Accessories) , under working
of the device (power on state) use RJ-45
cable connection to ETH2 port and
function kit, after link about 5 sec remove
RJ-45 reset function kit the software will
reset to default. As shown.
ANT 1
ANT 2
ETH1 (PoE in)
ETH2 (RJ-45 Reset function kit used port)
RJ-45 port
