59
Technical instructions
Cm
-SOL
installed and set sensor tank 3 up
8.3.x.4.1. Sensor upper
It is necessary to set (choose) address (input) of the connected sensor
upper 3 (it is possible to connect sensor upper (it is possible to connect
an one free of 10 addresses, controller recommends input T6).
Sensor upper
Not exist
Factory settings
Not exist/T1/.../T10
8.3.x.4.2. Sensor type
Because of the much better precision in temperature reading (reading to
1 decimal place) pool sensor
ALWAYS
must be
NTC5K
(not in the
delivery).
If NTC sensor is installed, here must be changed from PT1000 to the
NTC.
Sensor type
PT1000
Factory settings
PT1000/NTC
8.3.x. Enabled tanks
In this menu tanks can be enabled/disabled in the work of the system.
ENABLED - tank is enabled (included) in work of the system
DISABLED - tank is disabled (removed) from the work of the system (to
this tank pumps, valves and additional heating doesn’t work).
Tank 1
Enabled
Factory settings
Enabled/Disabled
Tank 2
Tank 3
Tank 4
Enabled
Enabled
Enabled
8.3.x. Tank priority
Setting the priority for the solar filling of the tanks. Tank 1 always must be
first in priority, other can be rotated according the filling priority. Priority of
each tank is marked on the upper left corner of the tank (green number),
below tank order number (black number).
Factory settings
2 tanks
3 tanks
4 tanks
12
123
1234
12
123 / 132
1234/1243/1324/1342/1423/1432
Installation, tank
Enabled/Disabled
Enabled/Disabled
Enabled/Disabled
example: set 3 tanks
example: set 3 tanks
example: configurated 3 tank (2 with 2
sensors, 3. tank = pool), 1
vacuum tube collector, back flow
sensor, zone 3-way valve
selection
selection
selection
selection