Page
22
of
41
The speed and torque settings can be
adjusted at any time by moving the
dials either clockwise or anti-clockwise.
The machine will slow instantly but will
accelerate
slowly
as
previously
described.
After 30-50m of fibre has been
installed it will be necessary, as
resistance increases, to introduce
airflow down the tube. Turn the
knob on the needle valve as
indicated to allow air into the
system. This valve should provide
a degree of control over the air
pressure used.
A lower pressure is beneficial at first; with
increasing distance the pressure should be
increased to maintain installation speed.
Consult the pressure gauge for your current
system installation pressure.
DO NOT EXCEED THE MAXIMUM SYSTEM
PRESSURE OF 15 BAR OR OPEN THE
MACHINE WHEN UNDER PRESSURE,
SERIOUS INJURY MAY RESULT.
