Page
23
of
41
The installation of fibre should now be semi-automatic. If the buckle function
is not in use then the machine will come to a stop when there is a blockage;
the fibre will be undamaged as there will not be enough torque to break it.
Once the machine has come to a stop, press ‘stop’ on the remote to prevent
the machine continuing when the blockage is rectified.
If the buckle function is in use then the
machine will automatically slow or stop
if it comes up against a resistance. If it
comes to a stop then it will reverse to
straighten the fibre before continuing; it
will reverse a maximum of three times
before considering there to be a
blockage at which point the installation
will be halted.
The following display will be visible along
with the red LED. It will now be
necessary to investigate the cause of the
blockage
and
remove
it
before
attempting to continue.
Once safe to do so, open the
machine and reset the buckle
shuttle. The ‘OK’ option will
then appear; pressing this takes
you back to the installation
screen and will allow viewing of
the
current
installation
distance. This may be needed to help remove the blockage.
Once all blockages have been removed the installation can resume to
completion. When the route has been completed press ‘stop’, turn off the air
supply and allow any pressure in the system to dissipate. You may then open
the machine and retrieve the fibre.
