Cavium FastLinQ 45000 Series, User Manual

Page: 110 / 342

6–Boot from SAN Configuration
iSCSI Boot from SAN
83 BC0154501-00 P
 IPv4* Default Gateway
 IPv4* Primary DNS
 IPv4* Secondary DNS
 Virtual LAN ID : (Optional) You can isolate iSCSI traffic on the network
in a Layer 2 vLAN to segregate it from general traffic.To segregate
traffic, make the iSCSI interface on the adapter a member of the
Layer 2 vLAN by setting this value.
 iSCSI Name . Corresponds to the iSCSI initiator name to be used by
the client system.
 CHAP ID
 CHAP Secret
3. Select iSCSI First Target Parameters ( Figure 6-14 on page 72 ), and then
press ENTER.
Configuring the iSCSI Targets
You can set up the iSCSI first target, second target, or both at once.
To set the iSCSI target parameters on Windows:
1. From the Main Configuration page, select iSCSI Configuration , and then
select iSCSI First Target Configuration .
2. On the iSCSI First Target Parameters page, set the Connect option to
Enabled for the iSCSI target.
3. Type values for the following parameters for the iSCSI target, and then press
ENTER:
 IPv4* Address
 TCP Port
 Boot LUN
 iSCSI Name
NOTE
For the preceding items with asterisks (*), note the following:
 The label will change to IPv6 or IPv4 (default) based on the IP
version set on the iSCSI General Configuration page (see Figure
6-11 on page 69 ).
 Carefully enter the IP address. There is no error-checking
performed against the IP address to check for duplicates, incorrect
segment, or network assignment.