Case IH 84336239, Operator'S Manual

Page: 43 / 179

SECTION 1 - GENERAL INFORMATION AND SAFETY
1ï9
inflated to the pressures given in: Section 4
Lubrication and Maintenance.
Check the wheel nuts torque daily during the first
week of operation and thereafter on a weekly basis.
The wheel nuts torques are given in:
Section 4-80 Lubrication and Maintenance.
SAFETY DECALS
Safety decals are placed on your machine as a guide
for your safety. Walk around the machine and note
the content and loaction of these decals before
operating your machine.
Following is a listing of Safety Decals and locations.
Read and the understand them before operating the
machine.
Decal Inspection and Maintenance
1. Cleaning decals.
• A. Keep decals clean and legible
• B.Use a soft cloth, water, and a gentle detergent.
•
C.Do not use solvent, gasoline, and other harsh
chemicals which may damage or remove the
decals.
2. Replace all decals that are damaged, missing,
painted over or illegible. Refer to your dealer for
replacement decals.
3. If a decal is on a part that is replaced, make sure
the decal is installed on the new part.
1. Caution: Door is spring loaded stay clear
2. Warning: Close shield during baler operation
3. Danger: Rotating drive line, keep away
4. Warning: Read the Operator's Manual
3
IMPORTANT: Decals which display Read Operator's Manual symbol are intended to direct the operator to the Operator's
Manual for further information regarding maintenance, adjustments, and or procedures for particular areas of the
machine. When a decal displays this symbol refer to the appropriate page of the Operator's Manual.