Case IH 84336239, Operator'S Manual

Page: 163 / 179

SECTION 2 - CONTROLS, INSTRUMENTS AND OPERATION
2ï105
Mistie function disabled
When all but 2 mistie sensors have an error state, the
message `mistie function disabled' will appear.
Press `escape' to clear the message, but be aware
that no mistie monitoring at all is taking place until the
failures are repaired. Warning indicator in the status
bar reminds the operator of a failure status.
Call your dealer for assistance.
Maximum PTO speed
An overspeed warning message is displayed when
the baler speed exceeds 1100 rpm.
Slow down PTO speed to 1000 rpm for optimum
performance and to prevent damage to the baler. This
will clear the warning message.
223
Cutter knives out (crop cutting system
machines only )
On crop cutting system machines, this message
appears when the knives are not in cutting position
(knife control cylinder is not fully extended).
The message remains on the screen until the knives
are fully engaged (operate the tractor hydraulic valve)
or the 'escape' key is pressed.
When the crop does not need to be cut, fully retract
the knives and press `Escape' to clear the message.
NOTE: This warning message does not appear on the
screen for knives breaking‐away from overload,
overfeeding or foreign material e.g. stones, entering the
baler.
224
222