ADJUSTING LEGS
RIGHT SIDE
LEVELING GAUGE
WRONG
RIGHT
1. Installation Procedures
1.1 Cautions
A.) Environment: This scale must be installed in a dry and liquid free environment.
B.) Location: This scale must be placed on a flat and stable surface. Please keep the scale away from
oscillating fans, ventilation systems, or drafts as these air disturbances can be picked-up by the scale
and may cause incorrect weight readings.
C.) Leveling: If the scale is not properly level, please adjust the 4 legs at the bottom of the scale
(turn legs clockwise or counter-clockwise) so as to center the bubble of the leveling gauge inside the
indicated circle. (See below Fig.)
LEVELING GAUGE
NOTE: Scale is to be used indoors ONLY
D.) The power outlet should be near the equipment and be easily accessible.
E.) Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.
1.2 How to Assemble the Pole Display
If your scale is a “Pole Type”, please follow the instructions in this section.
If your scale is a “Non-Pole Type” then continue to the next section.
To begin installing the Pole Display make sure you have the Display Bracket,
the Pole Display and the Ferrite Core. (Refer to Fig.)
POLE DISPLAY
POLE DISPLAY BRACKET
7
FERRITE CORE
