Carver 46 VOYAGER, Owner'S Manual

Page: 74 / 180

AC E
LECTRICAL
S
YSTEM
S
ECTION
3
4627 5/04
breaker group consists of either two (for Europe) or three (for North
America/Pacific Rim) circuit breakers that operate together.
A sliding lockout plate prevents you from switching “ON” both the Shore
and Generator breaker groups for the same Line circuit. Slide the lockout
plate to the position necessary to expose the breaker group that you wish
to use.
For the North American/Pacific Rim AC Control Center:
Shore - Switch this breaker group “ON” if you are using a shore power
source to provide electricity to the boat’s AC electrical system.
Generator - Switch this breaker group “ON” if you are using the generator
to provide electricity to the boat’s AC electrical system.
For the European AC Control Center:
Shore 1 - Switch this breaker group “ON” if you are using a shore power
source to provide electricity to the Line 1 circuit breakers.
Generator (upper) - Switch this breaker group “ON” if you are using the
generator to provide electricity to the Line 1 circuit breakers.
Shore 2 - Switch this breaker group “ON” if you are using a shore power
source to provide electricity to the Line 2 circuit breakers.
Generator (lower) - Switch this breaker group “ON” if you are using the
generator to provide electricity to the Line 2 circuit breakers.
3.3.2.7 Power Available Indicator
This indicator illuminates when your boat is connected to a working
shore power source.
3.3.2.8 Reverse Polarity Indicators
If reverse polarity occurs, immediately switch the respective Shore circuit
breaker group(s) “OFF.”
These indicators illuminate when the polarity of the shore power source for
the Line 1 and Line 2 circuits is incorrect. Refer to “Shore Power” earlier
in this section for information on correcting reverse polarity. These
indicators are present only if your boat was built for use in Europe.