Carver 46 VOYAGER, Owner'S Manual

Page: 56 / 180

DC E
LECTRICAL
S
YSTEM
S
ECTION
2
4627 5/04
switch this breaker “ON.” Refer to the OEM information for details on
operating the GPS and plotter.
2.2.2.46 Raydata Repeater
This breaker controls the flow of electricity to the optional Raydata
repeater system. To supply power to this sytem, switch this breaker
“ON.” Refer to the OEM information for details on operating the Raydata
repeater.
2.2.2.47 TV Monitor System
This breaker controls the flow of electricity to the optional video surveil-
lance system. This system uses closed-circuit television cameras to monitor
the engine room and the area immediately aft of the boat. Both cameras are
connected to a video display. Refer to the OEM information for details on
operating the video surveillance system.
2.2.2.48 Spare
These breakers are reserved for aftermarket accessories you install on your
boat.
2.2.3 Bridge Breaker Panel
The Bridge Breaker Panel, located beneath the double-wide starboard
lounge on the bridge, manages the power supply to various safety lights and
bridge 12-volt equipment. Each circuit breaker on this panel has a control
switch associated with it; the control switches are located at the helm. The
circuit breakers are normally “ON” and cannot be manually switched
“OFF.” If a circuit breaker trips, identify and correct the cause of the prob-
lem, then press the breaker’s reset button on this panel. To provide power
to this breaker panel:
1. Turn the “house” battery master disconnect switch to the “ON” posi-
tion.
2. On the Safety Breaker Panel, switch the Main - Two circuit breaker
“ON.”
3. On the DC Control Center, switch the Bridge DC Main circuit
breaker “ON.”
The Bridge Breaker Panel contains the circuit breakers described below.
2.2.3.1 Horn
This breaker controls the flow of electricity to the switch that operates the
horn.