Using SensorScan to determine the best location for devices
Wireless Sensors
CARRIER CORPORATION ©2018
Installation Guide
All rights reserved
26
Use the SensorScan software to verify that your proposed locations for sensors and the Wireless Adapter will allow
a strong wireless signal. If needed, review
Wireless device placement guidelines
(page 18) for locations or
obstacles to avoid.
PREREQUISITES
•
A computer with Microsoft® Windows operating system
•
USB Radio
Step 1: Download and install SensorScan
1
On the computer, go to
http://www.hvacpartners.com
(
http://www.hvacpartners.com
), select
Support Center
>
Controls Support
>
Software Downloads
>
i-Vu Technicians Tools
, and then download
SensorScan_Setup.exe.
2
Insert the USB Radio into a USB port on your computer.
3
Run SensorScan_Setup.exe and follow the prompts to install the software.
4
Start the SensorScan application.
•
If the USB Radio driver installed correctly, the application should show something similar to the image
below.
•
If the driver did not automatically install correctly, see
To install the USB Radio driver
(page 25).
NOTE
The USB Radio can talk to only one application at a time. If you need to run SensorBuilder and SensorScan
simultaneously, you can do either of the following:
•
Use two USB Radios.
•
Turn off communication with the USB radio in the current application, then switch to the other application and
turn on the USB communication.
Using SensorScan to determine the best location for devices
Summary of Contents for WIRELESS ADAPTER
Page 65: ......