Pairing sensors to the Wireless Adapter using SensorBuilder
Wireless Sensors
CARRIER CORPORATION ©2018
Installation Guide
All rights reserved
22
To enable communication between wireless sensors and their Wireless Adapter, you must use the SensorBuilder
application to pair the devices. We recommend that you pair the sensors with the Wireless Adapter before
installing the devices to save time.
PREREQUISITES
•
Computer with a current Microsoft® Windows 7, 8 or 10 operating system
•
USB Radio
•
Wireless Adapter connected to a 24 Vac power source. See
To install the Wireless Adapter
(page 30) for
power connector location.
•
QR Scanner (Optional). See step 5 in
Step 2: Pair sensors to the Wireless Adapter
(page 23).
NOTES
•
SensorBuilder automatically assigns each wireless sensor an RnetID (starting with 0) that is the sensor's Rnet
address; you cannot set the address on the physical sensor.
•
You can pair a sensor to multiple Wireless Adapters.
Step 1: Download and install SensorBuilder
1
On the computer, go to http://accounts.automatedlogic.com/download. On the
Download
page, go to
Engineering and Startup Tools
>
Wireless Sensor Software Tools
>
SensorBuilder
, and then download
SensorBuilder_Setup.exe
.
2
Insert the USB Radio into a USB port on your computer.
NOTE
The orange antenna should be straight. A bend in the antenna could degrade the signal.
Pairing sensors to the Wireless Adapter using SensorBuilder
Summary of Contents for WIRELESS ADAPTER
Page 65: ......