Carlisle BGK AutoCure 6000-2216, Assembly And Operating Manual

Page: 14 / 57

1. While running a cycle without a second ramp set up in the controller, operator may
toggle the start button a second time resulting in bypassing the ramp feature.
2. While running a cycle with a second ramp set up in the controller, operator may toggle
the start button a second time resulting in bypassing both ramps and going directly to
second cure temperature without ramping feature.
3. Pushing the E-stop button will stop the current heating cycle.
NOTE: These are procedures that give reliable results for most repairs. Unusual or
complex repairs might need modified procedures. Contact BGK service for
assistance.
Yellow Pendent (for overhead arm movement)
The yellow pendant has a button labeled “Beam On” and “Start”. Toggling the “Beam on”
activates the position beam and toggling the start button will initiate the heating cycle. Refer
to “Setting the Temperature Controller Parameters” in the Operating Instructions for further
instructions.
The controller has the following programmed features which allow the operator some
flexibility on running heating cycles: