26 of 55
8.11 Board Switch
1
Used for accessing other controller displays
on the network.
Changing the address of the unit, allows this
interface to access a unit at a different
location.
8.12 Service
(Initial password is 0000)
The choices are accessed by using
the
UP
and
DOWN
buttons to scroll
the choice to the stationary arrow
line.
Then press ENTER to make your selection
and go to that next screen.
Pressing ESC will return you to the previous
Menu.
a. Language - 1
a. Language - 2
Used for selecting the interface language.
Options: English, Italiano
Used for setting the language startup mask.
If disabled, the language can be set in this
service menu.
b. Information - 1
b. Information - 2
Used for reading information about the
software version, Bios, Boot, and pCO type.
d. Working hours - 1
Used for reading the run hours of the pump.
Service Menu
a. Change Language
b. Information
d. Working hours
e. BMS Config
f. Service Settings
g. Manual management
Summary of Contents for humiFog UA1K0HM00
