27 of 55
e. BMS Config - 1
Used for setting up the communication
network.
Options: LonWorks, Winload, Modbus,
Kyocera, BACNet
Note: Some communication protocols will
require additional software and hardware.
8.12.1 Service Settings
a. Working hour set - 1
a. Working hour set - 2
Used for reading the run hours of the pump,
and also for setting the alarm time for pump
operation:
Note: See maintenance section for
recommended service intervals. Interval
should be set for maximum of 1000hours.
Used for resetting the “Run” hour, and
“Alarm” hour counters.
b. Probe Adjustment - 1
b. Probe Adjustment - 2
Used for calibrating the pressure
transducer.
Used for calibrating the conductivity sensor.
d. User DEV/Change PW1 - 1
Used for setting/changing the service
password (PW1).
Default password is: 0
Summary of Contents for humiFog UA1K0HM00
