Carel humiFog UA1K0HM00, User Manual

Page: 27 / 54

28 of 55
8.12.2 Manual Management
g. Manual management - 1
Used for manually operating the pumping
station.
Note: When in manual control of the pump,
make sure there is at least (1) open
manifold or circuit for water distribution,
otherwise the pump can be damaged by
overheating.
8.13 Manufacturer
(Initial password is 0000)
The choices are accessed by using
the
UP
and
DOWN
buttons to scroll
the choice to the stationary arrow
line.
Then press ENTER to make your selection
and go to that next screen.
Pressing ESC will return you to the previous
Menu.
8.13.1 Configuration
a. Pump Settings - 1 2 3
Used for setting the pump acceleration and
deceleration rates.
This allows the pump to stage up and down
in small step increments. Used for selecting the units of measure for:
Temperature: °F / °C
Pressure: psi / kpa / bar
Capacity: lb/hr / kg/hr Used for setting the pump temperature
activations, and alarms.
Used for activating the leak detection alarm.
8.13.2 I/O Configuration
b. I/O Configuration - 1 2 3-4
Used for selection high pressure sensor
configuration:
0-10Vdc, 0-1Vdc, 4-20mA Used for selecting/activating the bypass
temperature sensor, and the conductivity
sensor. Used for enabling/disabling the low
pressure switch, high pressure switch, vfd
alarm, and remote On/off.
Manufacturer Menu
a. Configuration
b. I/O configuration
c. Factory Settings
e. Initialization
135.0
150.0
10.0