![background image](http://html1.mh-extra.com/html/cardin/s504-series/s504-series_manual_2556004026.webp)
26
7. Activating the user code
Keypad function
- Type the user code into the keypad and press " ".
- The keypad will sound a two-second long
beep
with the
green
led lit.
The code has been accepted.
- Press A-B-C or D in the right hand column of the keypad (e.g. "
C
").
Activation successful.
Transponder reader function
- Move a
tag
containing the channel you wish to activate near to the
transponder reader
.
- The reader will sound a
beep
with the green
led
lit.
Activation successful.
If you have inserted an invalid user code or a non memorised tag or card the interface will beep 3 times.
8. Setting the remote RFID reader DKSTPT (Dip 1, 2, 3 and 4)
To access the selection dips remove the electronic card protection panel.
9. Setting up the DKSDUALT keypad
Once the keypad has been installed, enter the service mode to set the operating parameters
To set the optional parameters type
#
password
on the keypad.
The keypad will sound one 3-second long
beep
and the green led "
L1
" will flash quickly.
The service mode remains active for 20 seconds.
If the password is wrong the
red
led will flash quickly five times
The default password is 123456.
dip 3 dip 4
Device address
If multiple DKSTPT or
DKSDUALT devices are
connected to the interface
each of them must be set
up with different device
addresses.
OFF OFF 1st device address
ON
OFF 2nd device address
OFF
ON 3rd device address
dip 1 dip 2
Indicator modes
(1)
event
: the indications are activated
when a tag / card is detected.
(2)
low
: backlighting always active at
low intensity
(3)
high
:
backlighting always active at
high intensity
OFF OFF buzzer OFF - backlight OFF
ON OFF buzzer ON - backlight ON -
event
(1)
OFF ON buzzer ON - backlight ON -
low
(2)
ON
ON buzzer ON - backlight ON -
high
(3)
1
2
ON
1
2
ON
Summary of Contents for S504 Series
Page 99: ...99 Notes...