22
• The DKS devices are suitable for outdoor use (
IP57
).
• The DKS devices must be positioned in sight, away from moving parts and at a height of at least
1.5 m
.
• Caution! In order to avoid a reduction in the transmission range of the DKS transponder device never install it directly on metal
structures.
Installing the transponder reader DKSTPT (fig. 5)
•
Once you have decided on the definitive position, unscrew the two holding screws "
1
" and separate the base "
2
".
Pass the connecting
cables "
3
", coming from the interface, through the wall, drill two holes in the wall "
3-4
" and fix the fastening base to the wall using the two rawlplugs and
screws "
5-6
". Rotate the transponder reader "
7
", unscrew the two holding screws "
8
" and remove the cover protecting the terminal block "
9
".
•
Pass the power supply / signal cable through the hole "
10
", bend it slightly "
11
" and wire it to the terminal block "
12
". Replace the terminal block cover
and fasten down using the screws "
14
". Rotate the transponder reader, hook it onto the upper part of the base "
15
" and rotating it slightly allow it to
snap onto the base "
16
", then fasten the reader using the two screws "
17
".
Installing the keypad with transponder reader DKSDUALT (fig. 6)
•
Once you have decided on the definitive position, unscrew the two holding screws "
1
" and separate the base "
2
". Drill the wall "
3
" fix the fastening base to
the wall using the two rawlplugs and screws "
4-5
", as shown ij the drawing. Rotate the keypad "
6
" and remove the six cover fastening screws "
7
".
•
Remove the base of the keypad "
8
". Make a hole in the rubber gasket and pass the power/data cable through the hole "
9
", bend the wires slightly and fasten
them to the terminal block "
10
" respecting the polarity "
11
". Replace the keypad base "
12
" and fasten down using the previously removed screws "
13
".
• Rotate the keypad, hook it onto the upper part of the base "
14
" and rotating it slightly allow it to snap onto the base "
15
", then fasten it using the two screws "
16
".
Installing the keypad DKS250T - DKS250TL (fig. 7)
•
Pass the connecting cables,"
1
" coming from the interface, through the wall.
Drill the wall at the distance indicated in figure
7a
(
58 mm
). Insert the
rawlplugs "
2
"supplied with the kit. Fasten down the counter plate "
3
" sing the screws "
4
" supplied with the kit. Connect the Fastons on the wires "
1
"
to the Fastons "
5
" (fig, 7a-7b). Position the keypad (fig 7b-7c) and fasten it down to the counter plate using the special screw "
S1
" and the tool "
K1
".
DKSTPT, DKS250T, DKS250TL AND DKSDUALT OPERATION
Montaggio Transponder
a superfice INOX
SSB-T9K4
01-04-2016
DM1009
Description :
Product Code :
Date :
Drawing number :
P.J.Heath
CARDIN ELETTRONICA S.p.A
- 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/401831
Draft :
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
INOX - FE
NO
Summary of Contents for S504 Series
Page 99: ...99 Notes...
