45929, EN - rev.6, 2019-03
27
Point-To-Point (P2P) Standard measuring
1. The only information in Point-To-Point Standard body measuring
that differs from the one in Normal measuring is the Distance ID.
Point-To-Point uses a combination of measuring view and point name.
In the example below the measured distance is point A to B in the
Engine compartment (EC). Also shown in the example is a typical
Point-To-Point measuring arm configuration.
Point-To-Point (P2P) Advanced measuring
1. For Point-To-Point Advanced the display shows the same
type of information as for Normal measuring.
Information in the status bar at the top of the display may vary.
The example below identifies the current distance to measure
(1 to 6 in a measuring situation).
