35
NOTE
If the switch has been set to ON
(Remote Controller), you cannot
control the TwinPact 100 from the
computer (Twin Commander).
Parameter values specified in re-
mote controller are not available
in PC (Twin Commander), and the
values specified in PC (Twin
Commander) are not available in
remote controller as well.
Tip
No. 2 3D Noise Reduction
Allows you to enable/disable the 3D Noise Reduction feature.
* Only available during S video input.
OFF: OFF
ON: ON
Digital 3D Noise Reduction
In a conventional method, noise is reduced by lowering the fre-
quency characteristics for the entire picture (blurring) in one or two-
dimensions. This method has a problem in affecting other parts not
containing noise. The digital 3D noise reduction feature employed
by TwinPact 100, however, removes noise after detecting noise
using the characteristic of noise (noise has little relation to others in
the time axis), the advert effect to the image is kept minimal.
* Because of its construction, it is not a universal solution for all noises.
No. 3 Scan Converter Control
No. 3 Scan Converter Control
Allows you to select which tool, computer (Twin Commander) or
remote controller, you use for adjusting the RGB input video. You
cannot operate TwinPact 100 using both the tools at the same time.
OFF: PC
ON: Remote Controller
No. 4 Audio Input
Specifies audio input terminal when RGB is input.
OFF: Rear
ON: Front
No. 5 Reserved
Not used (Usually, set it to OFF.)
No. 6, No. 7, No. 8 RGB Termination
When RGB input terminal is not connected to the external monitor,
set it to ON.
OFF: OFF
ON: ON
NOTE
When using a stereo mini-jack for
audio inputs during RGB input,
set this DIP switch to OFF (Rear).
When using a pin-jack, set it to
ON (Front).
Summary of Contents for TwinPact 100
Page 1: ...User Manual...
Page 10: ......
Page 11: ......
Page 33: ...23 Click OK 11 11 Playback the captured video and check the content 12 12...
