12
4. Control Command Format
This format is to transmit from the computer to VC-C50i.
Header
Device Num
Command
Parameter
End mark
Header
: 1 byte FFh
Device Num : 2 byte 3030h~3039h (Device number in cascade connection)
Command : 2 byte (refer to
12. Details of Pedestal Control Commands
~ 14. Details of System Control Commands
)
Parameter : Variable length If not specified, parameter manifests hexadecimal, transmits
its ASCII code.
End mark : 1 byte EFh
Just after power on, device number is 3030 and each device number is determined by
Cascade
ON
control command.
The control command (Global Command) of device number 3030 became valid to all VC-C50i
connected in
Cascade ON
status.
5. Answer Format
5.1 Answer Format
This answer format corresponds to the control command transmitted from the computer to
VC-C50i.
Header
Device Num
Error Code
Status
End mark
Header
: 1 byte FEh
Device Num : 2 byte 3030h~3039h (Device number in cascade connection)
Error Code : 2 byte manifested error flag In hexadecimal and return it's ASCII code.
Status
: Variable length If not specified, status manifests hexadecimal, transmits
its ASCII code.
End mark : 1 byte EFh
Under the condition in
Cascade Connection ON
, the answer corresponding to control
command of device number 3030, is returned only to the last device connected in cascade.
5.2 Error Code
Error code manifests error flag in hexadecimal and returns it’s ASCII code. If not exists error,
all bits of error flags are cleared and becomes zero.
•
The bit assignment of error flag.
b7(MSB) b6 b5 b4 b3 b2 b1 b0(LSB)
Mode error
Parameter error
Command error
Busy
System
reservation
System
reservation
System
reservation
System error
1st byte
b7: Mode Error
In case of wrong mode
b6: Parameter Error
In case of receiving wrong parameter
b5: Command Error
In case of receiving wrong command
b4: Busy
In case of unable to execute by error
