Canon VB-C50I, User Manual

Page: 32 / 233

2-4
1. Set Up the Camera
a
WARNING:
Install the camera securely.
●
When installing the VB-C50iR on the ceiling, contact your Canon dealer.
●
When installing the VB-C50iR on the ceiling, check that the ceiling is strong enough to
bear the weight of the VB-C50iR including the mounting plate. Installation in a weak
location could result in the VB-C50iR falling and causing serious injury.
●
At least once a year, check for looseness in the camera installation mount. (If the optional
wide converter is used, check the converter mount also).
Note
●
The permissible camera installation angles are
±
20
°
from the horizontal. (
±
15
°
when the optional wide converter is used for the VB-C50i).
●
The MAC address required when making network settings is shown on the bottom of
the VB-C50i/VB-C50iR (
→
P.1-10). Please make a note of it before installing this unit
(
→
P.2-8).
Note
●
Do not overtighten the mounting screw.
If excessive force is used to tighten the mounting
screw, camera head movement may be impeded,
or other malfunctions may result.
●
Always use a tripod mounting screw that is less
than 6.0 mm (0.24 in.) in length. The use of
screws 6.0 mm (0.24 in.) long or longer could
damage the camera. Also, the tripod seat used
should be at least 30 mm (1.18 in.) in diameter.
Firstly, set up the camera. Read the following carefully and make sure the camera is set up properly.
VB-C50iR Installation
Firmly tighten the 2 screws (not supplied).
(Installation)
• Distance between tapped holes: 120 mm (4.72 in.)
• Tapped hole diameter: 6.0 mm (0.24 in.)
• Mounting plate thickness: 1.6 mm (0.06 in.)
Screw
VB-C50iR
Mounting plate
Screw
Mounting
screw
Less than
6.0 mm
(0.24 in.)
30 mm
(1.18 in.)
or wider
VB-C50i Installation
Install in a flat and stable location.
Using a Tripod (VB-C50i)
The screw for mounting a tripod is on the bottom of the VB-C50i toward the front.