Canon iR2000 Series, Service Manual

Page: 493 / 738

CHAPTER 13 TROUBLESHOOTING
COPYRIGHT© 2002 CANON INC. 2000 CANON iR1600/iR2000/iR1610/iR2010 SERIES REV.0 MAR. 2002
13-115
[No. 05]
Use it to set the length of item (pause) automatically put between the access code an the
ID code when a number is dialed on an NCC (new common carrier) line.
[No. 06]
Use it to set the length of time (pause) automatically put between the ID code and the
telephone number of the other party when a number is dialed on an NCC (new common
carrier) line.
[No. 09]
Use it to set the number of TSI comparison digits (last XX digits) for a telephone number
cross check.
[No. 10]
Use it to set the length of time for line connection identification. If an error occurs often
because of the line condition at time of a communication, increase the parameter.
Memo
The line condition detection time length refers to the length between
when the dial signal is transmitted and when the line condition is cut in
relation to the transmitting side, while it is the length between when the
DIS signal is transmitted and when the line is cut in relation to the receiv-
ing side.
[No. 11]
The setting of the T1 timer varies from country to country (PTT). The T1 timer is vari-
able.
[No. 13]
If the length of data for a single line is too long (e.g., computer fax), increase the 1-line
transmission time for possible reception to prevent a reception error.
[No. 15]
Use it to set the hooking detection time.
[No. 16]
Use it to set the time length between when the line is acquired and when the pseudo RBT
is transmitted when making a fax/tel switch-over.
[No. 17, 18, 19]
Use it to set a pattern of the pseudo RBT signal transmitted when making a fax/tel switch-
over.
[NO. 20, 21, 22]
Use it to set the pattern of the pseudo CI signal transmitted when making a fax/tel switch-
over.