Canon iR2000 Series, Service Manual

Page: 492 / 738

CHAPTER 13 TROUBLESHOOTING
COPYRIGHT© 2002 CANON INC. 2000 CANON iR1600/iR2000/iR1610/iR2010 SERIES REV.0 MAR. 2002
13-114
No.
62
63
64
65
66
67
68
69
70
Function
wait time for reply from the server
(SMTP transmission)
wait time for reply from the server
(SMTP transmission)
wait time for reply from the server
(POP reception)
wait time for reply from the server
(FTP transmission)
communication time-out length
(SMTP transmission)
communication time-out length
(SMTP reception)
communication time-out length
(POP transmission)
communication time-out length
(FTP transmission)
number of text lines possible for
mail reception
Range of settings
0 to 65535 sec
0 to 65535 sec
0 to 65535 sec
0 to 65535 sec
0 to 65535 min
0 to 65535 min
0 to 65535 min
0 to 65535 min
0 to 65535 lines
Initial
300
300
300
300
60
60
60
60
300
Remarks
T05-504-03
[No. 02. 03, 04]
Use it to set conditions for RTN signal transmission. If an error occurs often when the
RTN signal is transmitted at time of reception, increase the parameters to loosen the RTN
signal transmission conditions.
Memo
The following error codes are associated with the transmission of the RTN
signal at time of reception:
##104, ##107, ##114, ##201
The RTN signal transmission condition (1) is the ratio of the number of
error lines in relation to the total number of lines per page of reception
images.
The RTN signal transmission condition (2) is the reference value
*2
for
burst errors
*1
.
The RTN signal transmission condition (3) is the number of errors not
reaching the reference value for burst errors.
*1: transmission errors spanning several lines.
*2: If set to ‘15’, a transmission error spanning 5 consecutive lines is
identified as a burst error.
If any of these conditions is detected while an image signal is being re-
vised, the RTN signal will be transmitted after receiving the procedure
signal from the transmitting machine. A higher parameter will make the
transmission of the RTN signal more difficult.