Canon imageRUNNER 5055 series, Service Manual

Page: 72 / 596

Chapter 2
2-16
F-2-67
<Attaching of the service book case>
1) Peel off the two-sided tape located at the back of the service book case [1]
to attach to the bottom plate of the host machine.
<Attaching of the shutdown label>
1) Put the appropriate language shutdown label [1] on the indicated position.
F-2-68
<Attaching of the document size label>
1) Broaden the document size guide plate [1] for A3/A3 position, and then
fit the [A] of the document side guide plate with the position of A4/A3 of
the document size label to attach the label.
F-2-69
<Attaching of the touch pen>
1) Set the touch pen [1] on the control panel.
F-2-70
<After installation of the host machine>
1) Clean around the machine.
2) Move the host machine to the specified position and fix it in place with the
2 adjusters.
Be sure that the front side of the service book case is exposed for 6mm
from the front side of the bottom plate [2] of the host machine when
attaching the service book case.
In case of attaching the service book case without any margin exposed
from the bottom plate, it will cause the service book case to run into the
rail of the paper deck when mounting the paper deck later.
Be sure to attach the paper deck first and then attach the service book case
in case of mounting the paper deck and attaching the service book case at
the same time.
Position forbidden to attach the service book case
- Inside the machine (inner side of the front cover)
- Position to block off the louver area
- Position to block off the grip area
[1]
[1]
[2]
[1]
6mm or more
[1]
[2]
MEMO;
The adjusters may be too hard to turn by hand. In such case, use a
screwdriver to turn.
[1]
A4
A3
A
[2]
[1]
[1]